10 station cable crossover, Forza FH

This ten station cable crossover concentrates a complete pulley based strength circuit into one structure. Ten independent stations share a single frame, so a club can serve ten users at once on cable work without lining up ten separate selectorised machines along a wall. It is aimed at commercial gyms, hotel fitness centres, corporate facilities and training studios that need throughput on a limited floor area.

Every station has its own transmission, which is what keeps the feel consistent across the frame: a user pulling on one column does not affect the resistance felt on the next. The range of movement covers the whole body, from chest flyes, presses and lat work through to rotational core exercises, hip and leg work at low pulley height. Because cable resistance stays constant through the movement and the line of pull can be varied by height and body position, one crossover replaces a long list of fixed path machines and adapts to rehabilitation, general fitness and athletic preparation programmes on the same equipment.

Structural steel sections, guards and bearings are specified for continuous commercial duty. Seats, pads and handles are dimensioned to fit a wide range of user sizes so that a club does not need to adjust the machine between every set.

Technical specification

Floor planning for a ten station crossover

The value of a ten station unit is throughput per square metre, but it only works if the surrounding circulation is planned properly. Each station needs a working zone in front of the pulley deep enough for a full cable stroke, plus a passing lane behind so members can move around the frame without walking through a live cable line. Positioning the crossover as an island in the centre of a strength zone usually gives better flow than placing it against a wall, since users can approach from both sides. Anchorage, ceiling height and the floor build up should be checked before ordering, and a weightlifting grade rubber tile is normally specified underneath. Our team supplies the implantation drawing and the anchorage schedule, delivers across France, Belgium, Switzerland and Luxembourg, and quotes export per project.

Frequently asked questions

What are the overall dimensions and the weight stacks?

Overall dimensions, ceiling height requirement and the weight stack per station are supplied with the layout study prepared for your room before the order is confirmed.

Can it be used by ten members simultaneously?

Yes. The ten stations are independent, each with its own transmission, so simultaneous use does not affect resistance on the neighbouring stations.

What warranty applies?

Commercial strength equipment is covered by a manufacturer warranty of 2 to 5 years depending on the component group, with spare parts and servicing handled by our after sales department in Tours.